Pick a floorplan — Use the dropdown menu at the top to select Small Home, Large Home, or "Upload Your Own…" to load a custom PNG or JPG floor plan image.
Add devices — Click "+ Add Device" to open the device configuration panel. With "Add device mode" checked (default), choose a device type and protocol, then click anywhere on the map to place devices rapidly — keep clicking to place more. Click an existing device on the map to switch to configuring that device instead. Uncheck "Add device mode" or click "Done" when finished. A Smart Light on WiFi is placed by default.
Create a detection model — Click "+ Add Detection Model" to configure how occupancy is detected:
Multi-stream: Select 3–4 devices of the same protocol. Click "Create detection area" to create the area and immediately start selecting devices for the next one. Click "Finished" when done.
Single-stream: Select a Hub/Router/AP device, then select one or more spoke devices of the same protocol. The system creates individual stream lines between the hub and each spoke, each with a Stream output.
Run detection — Click the "Run" side of the toggle to start the detection models. Radio-frequency waves will emit from devices in detection areas. Drag the person icon(s) through the space to see occupancy and security detection respond in real time. Use "+ Add Person" / "- Remove Person" in Configure mode to change the number of people.
Arm Security — While in Run mode, click "Arm Security" to enable the security system. If any area's confidence in a security detection is sufficient, an intruder alert will flash for 3 seconds. Click "Disarm Security" to disable.
Configure to modify — Click the "Configure" side of the toggle to stop detection and return to setup mode. In Configure mode you can add, move, or remove devices; create or delete detection models; and adjust the number of people. Security is automatically disarmed when switching to Configure.
Save & Load configurations — Click the ⋮ menu (left of the sensify® title) to save or load your setup. "Save Config" downloads a ZIP file containing your devices, detection areas, people, camera position, and custom floorplan. "Load Config" restores a previously saved configuration from a ZIP file.
Scroll to zoom · Drag empty space, arrow keys, or middle-click-and-drag to pan · Two-finger drag on touchscreen to pan · Click devices to configure · Click trash icons on area panels to remove · Type "s" to save a screenshot
Note: This interactive demo shows representative outputs meant to illustrate how sensify® would work in a smart-home environment. The confidence levels, wave patterns, and detection responses are visualized for demonstration purposes and are not intended to accurately simulate real-world RF behavior or sensor performance.
Pinch or scroll to zoom · Drag to pan · Add devices, create detection models, then click Run